Installation

<< Click to Display Table of Contents >>

Navigation:  Hardware Overview > Gateway and Converters > RMS-CONVERTER-100 >

Installation

To install the RMS-CONVERTER-100, it is necessary to connect it to the Ethernet network and supply power.

 

Note:

If the RMS-CONVERTER-100 is already installed within an RMS system, the device is then write-protected and no changes can be made to the device. In order to carry out changes within the device, the device must be removed from RMS or disabled within RMS.

 

oUnpacking an RMS-CONVERTER-100

oConfiguration

oPairing of the RMS-CONVERTER

oSettings of the RMS-CONVERTER

oIntegration of the RMS-Converter into RMS

oIntegration of Rotronic conventional products into RMS

oIntegration of third party products into RMS

oModbus Editor - Integration of Modbus TCP products into RMS