Settings of the RMS-CONVERTER-100

<< Click to Display Table of Contents >>

Navigation:  Hardware Overview > Gateway and Converters > RMS-CONVERTER-100 > Installation >

Settings of the RMS-CONVERTER-100

WebService path:

In the case of an on-premise server, the WebService path must be adapted to the local settings of the local server. After correct configuration, the RMS-CONVERTER-100 can be integrated into RMS.

 

 

RMS-Converter_service path_V1.5.0

Figure 1: Update of the WebService path for any on-premise servers.

 

In case of a local server, the WebService path must be adapted to the local settings of the local server.

 

Important:

For a successful integration of the RMS-CONVERTER-100 into RMS, the network port 80 must be opened. The RMS-CONVERTER-100 must be able to send data to the RMS server (on-premise or cloud):

oIn case of an active DHCP: A DHCP server must supply an IP address automatically.

oIn case of fix IP: the network administrator can manually set a fixed IP address for the RMS-CONVERTER-100.

 

FW Update via RMS:

See chapter - SW configuration

 

Upload CA Certificate:

In protected IT infrastructures, the use of a CA certificate could be mandatory to identify that the RMS-CONVERTER-100 is a permitted network participant.

For that reason such a CA certificate can be uploaded to the RMS-Converter.

Please click on Upload CA Certificate at the Settings (via Browser/RMS Config) - see Figure 1 above.

 

Restart Converter:

Push the button to restart the converter.

 

Updated: 02.10.2023