The CCD probe series is based on digital technology. The probes have a UART interface.
The CCD probe series is developed for use with all RMS data loggers, compatible from Firmware version RMS-LOG-868/915 (≥V1.5), RMS-LOG-L (≥V1.4) and the RMS-LOG-L-D.
The CCD can be operated independently using the digital protocols, for example for integration into OEM applications. The following functions are available via the digital interface:
oChange device settings.
oCO2 adjustment.
oSimulator mode.
RMS-Config
This SW tool is used for configuration, customer adjustment and measurement using the probe out of the RMS SW.
The following information and function are available:
oProbe information: serial number, probe address, FW version and FW update
oRead out measurements
oProbe settings: Filter and simulator function
oAdjustment
Hardware and software compatibility
The CCD is compatible only with RMS-generation devices. To change the CCD device configuration, the RMS-CONFIG software is required.
|
Device Manual•Configuration with RMS-CONFIG
|
RMS
 |
