Housing

<< Click to Display Table of Contents >>

Navigation:  Hardware Overview > Sensors and Probes > CCD-S >

Housing

Functions

Description

Diameter

32 mm (1.26")

Length

76 mm (3")

Housing material

Polycarbonate, black

 

 

Connector

All CCD probes use the same connector (male).

 

Connection diagram (7-pin connector, male – view: probe side)

CCD_connection-diagram

1)        V+

2)        GND

3)        UART RxD

4)        UART TxD

5)        UART TxD_EN

6)        –

7)        GND

Connection diagram (7-pin connector, controller side)

CCD_connection-diagram2

 

 

Sensor protection (filters)

The CCD is supplied with a standard filter.

 

 

Mechanical installation

For best measurement results, observe the following points:

oFor indoor air quality measurements, the CCD should be installed at the light switch height (roughly 1200 mm from the floor)

oFor life safety measurements, the CCD should be installed at socket level (roughly 450 mm from the floor)

 

 

Electrical installation

Use Rotronic extension cables. These allow a maximum length of 5 m.