Hello, I am hoping for some clarification of the "Connection Timeout" statement in the Modbus communication section of the RMS-LOG-L manual....

The LAN-converter lost connection with the RMS cloud and this since 29/3/2020 around 07h00 (without external reason). His status is “Timeout”.
When...

This article describes the measurement principle of the relative humidity measurement based on a water sensitive capacitance.

Generally, an electrical capacitance depends on

• The surface A,
• The distance between the electrodes d and
• The permittivity εof the dielectric

Water content in the dielectric influences the permittivity and by this way the capacitance as well. This effect is used to get a rate of humidity of the gas (e. g. air) surrounding the sensor.
...

Question:
In the chart view, some of the parameter banners are in French and some in English. How can I get them in one language?

Possible...

General
This article gives an introduction into the temperature measurement by NTC Sensors.


Measurement principle
A NTC Sensor is a temperature sensitive resistance with a Negativ Temperature Coefficient (NTC). Therefore, the resistance of the sensor can be measured and converted into the corresponding temperature value. The higher the temperature, the lower the sensors resistance. ...

Hello, I am hoping for some clarification of the "Connection Timeout" statement in the Modbus communication section of the RMS-LOG-L manual....