<< Click to Display Table of Contents >> Navigation: Hardware Overview > LOG Dataloggers > RMS-LOG-L-D |
The RMS-LOG-L is a RMS logger with the following main function:
•Request of a measurement on the connected digital probes (1 or 2 measurement values)
•Transmit the measurement and system information to the RMS Webservice via Ethernet
•Store measurement data and time stamp during an interruption of communication and supply the data afterwards to the RMS
Important: The RMS-LOG-L-D cannot be used as a stand alone device without RMS. The RMS-LOG-L-D cannot recognize when the RMS-HCD is setup with dew/frost point and temperature and will show an error.
The values on the display will only show, this cannot be configured: 1.Hundreds: 1xx.xx (if no hundreds, then no value will be shown). 2.Tens: x1x.xx. 3.Ones: xx1.xx. 4.Tenths: xxx.1x. 5.Hundredths: xxx.x1. |
Device Manual
|
RMS
|