Technical specification

<< Click to Display Table of Contents >>

Navigation:  Hardware Overview > LOG Dataloggers > RMS-LOG-L-D >

Technical specification

General


Device type

RMS Data Logger with display

Range of application

-20..70 °C / 0..100 %rh

Measured Parameters

oHumidity & temperature with HygroClip HCD-S

oDifferential pressure with PCD-S

oCO2 with CCD-S

oTemperature with TCD-S

IP protection

IP651

Storage and transport conditions

-20..30 °C / 0..100 %rh

Data memory

44,000 pairs of measured values

Interfaces        

Ethernet

Protocols        

HTTP & MODBUS TCP

Software compatibility

≥V1.1        

≥V1.2.1

To confirm

If the device is in timeout, the alarm limits are stored on the device and in the case of excursions, the display will turn red (if battery only, then no backlight) and will beep (if so configured).

Power supply


Supply voltage

24 VDC ±10 % / <100 mA2  

PoE: 802.3af-2003, Class 1

Battery

Current consumption

<100 mA

Polarity protection

Yes

Battery life

The batteries of RMS devices typically last 3 years under the optimal conditions:

Temperature = 20°C±5°C.

Wireless signal strength >-60 dBm.

Limited “read out data” events in the audit trail.

Start Time and Measurement Interval


Start time

LAN display: <20 s

Measurement interval        

10 s to 15 min (the refresh rate is the same as the measurement interval).

Housing Specifications


Housing material

ABS

Dimensions

105 x 113 x 38 mm

Weight

200 g

Conformity


EMC directives

RMS-LOG-L

EMC Directive: 2014/30/EU

LVD Directive: 2014/35/EU

 

oEN 61326-1:2013 (Industrielle Umgebung)        

oEN 55011:2016, class B        

oEN 55032:2016        

oEN 61010-1:2010        

oEN 50581:2012

oIEC 61326-1:2012 ed2.0 (Industrial Environment)

oIEC CISPR 11:2015; class B

oIEC CISPR 32:2016

oIEC 61010-1:2010

oIEC 50581:2013-02

 

Performance criterion: www.rotronic.com

Soldering material

Lead free (RoHS Directive 2011/65/EU)

FDA/GAMP directives

FDA CFR 21 Part 11 / GAMP5

 

1 IP65 protection is only fulfilled, when rubber plug is used for cabling.

2 Power supply requirements: 24 VDC ±10 % / >4 W / limited power source