Hi, I am connecting the Hygroclip2 with Arduino and then to my PC, I am trying to change the device 485 address using the "REN" command, but it didn't work. Any suggestions? Thanks
Announcement
Collapse
No announcement yet.
Hygroclip2 change 485 address
Collapse
X
-
Hi Jzerun,
why not use the HW4 SW to change the RS485? The SW is free for device configuration.
Download here
Clemens
-
Hi jzerun
The Command is as followed:
Command format:The checksum can be substituted with "}"β{β ID Adr βRENβ Serial number + new address Chksum
For example programming the address 04 to the HC2A Probe with the serial "20294381" and address "00":
{F00REN 0020294381;04;}
Please note, that the Serial number must have 10 digits. So usually you need to add "00" to the serial.
- Likes 1
Comment
-
Depending on the model of your HygroClip2 device, there might be a specific button combination or interface to access the configuration mode. Refer to the device manual for instructions on how to do this.
Watermelon Game
Comment
Comment