By entering a serial number, the device history (device changes made by an NFC Station) can be displayed.
Overview
Every change of the device done by the NFC Station is listed from newest (top) to the oldest (bottom).
In the overview there are the following information listed:
•Date & Time: When the change occurred
•User: Which user did the change
•OrderNr.: Order code of the device
By clicking on “SHOW DETAILS” more information will unfold about the changes of the device (old and new values), see more in chapter Show Details.
Show Details
After “SHOW DETAILS” was selected, all adjustable values will be shown with the “Old value” compared with the “New value”.
The adjustable values include the following values:
•CalcSelection: Selected parameter for the calculation
•DisplayUnit3: Build in Display (Yes = ON / No = OFF)
•OutputXSelect: Selected parameter for the Output X
•OutputXRange: Chosen output X (current or voltage)
•OutputXScaleLow: Lowest scaling for output X
•OutputXScaleHi: Highest scaling for output X
•SelectedUnitX: Selected unit for output X (metric or imperial)
•ModbusRTUAdress: Modbus RTU address (default = 0)
•ModbusBaudrate: Modbus baud rate (default = 9600)
•ModbusParityBit: Modbus parity bit configuration (needs to be the same for Maser & Slave)
•ModbusStopBit: Modbus stop bits configuration (needs to be the same for Maser & Slave)
•ModbusByteOrder: Modbus byte order configuration (needs to be the same for Maser & Slave)