<< Click to Display Table of Contents >> Navigation: Hardware Overview > Sensors and Probes > HCD-Sx > Technical specification |
General |
|
---|---|
Device type |
Humidity and temperature probe |
Range of application |
-40…+85 °C / 0…100 %rh |
Mechanical configuration |
See variants |
IP protection |
IP65 |
Power supply / connection |
|
Power supply (VDD) |
2.8…5.5 VDC ±0 % |
Current consumption |
<0.5 mA |
Maximum inrush current |
<200 mA for 50 µs |
Maximum operating current |
<2 mA |
Polarity protection |
Mechanical protection |
Humidity measurement |
|
Sensor |
ROTRONIC HYGROMER® HT-1 |
Measurement range |
0…100 %rh |
Measurement accuracy |
±0.8 %rh at 10…30 °C |
Long term stability |
<1 %rh / year |
Sensor response time |
Typically 30 sec, for 63 % of 35 to 80 %rh step (1 m/s wind speed at sensor) |
Temperature measurement |
|
Sensor |
Pt1000 RTD, IEC 751 1/3 Class B |
Measurement range |
-40…+85 °C 1 |
Measurement accuracy |
±0.1 °C at 10…30 °C |
Long term stability |
<0.1 °C / year |
Sensor response time |
Typically 3 min, for 63 % of the temperature change (1 m/s wind speed at sensor) |
Calculated parameters |
|
Psychrometric calculations |
None |
Start time / measurement interval |
|
Start time |
90 ms (typical) |
Measurement interval |
500 ms (typical) |
Digital interface |
|
Type |
UART |
Factory default |
Baud rate 19200, tolerance 2 % Parity: none Data bits: 8 Stop bits: 1 Flow control: none |
Logic levels |
Logic 0: ≤0.4 V Logic 1: ≥2…2.5 V |
Maximum cable length |
3 m |
Conformity |
|
CE / EMC |
EMC Directive: 2014/30/EU
EN 61000-6-1:2007 EN 61000-6-2:2005 EN 61000-6-3:2007+A1:2011+AC:2012 EN 61000-6-4:2007+A1:2011 EN 61326-1: 2013
Performance criterion: www.rotronic.com |
Soldering |
Lead free (RoHS Directive 2011/65/EU) |
FDA/GAMP directives |
Compatible |
Accepted environmental conditions |
|
Storage/transportation |
-50…+100 °C / 0…100 %rh, non-condensing |
Range of application (electronics) |
-50…+100 °C 0…100 %rh, non-condensing |
Maximum wind velocity |
See filter specifications |
Critical gases |
Please consider the sensor data sheet of the HT-1 sensor. Please contact Rotronic support for that. |
1The peak load at 200 °C is 100 h.