Configure your Display Event Count in Header Settings

<< Click to Display Table of Contents >>

Navigation:  Software Overview > RMS Monitoring Software > Working with the RMS Software > Configure RMS > Configure your System >

Configure your Display Event Count in Header Settings

Step 1

From the start page, click on "Tools" > "Setup":

 

configure repeate alarm settings step 1

 

Step 2

On the left side, select "System":

System New 1

Step 3

Scroll down to display event count in header:

System New 2

Under "Display event count in header", it is possible to configure the display event count in the header:

Pending Reminders: Display open reminders in the header.

Pending Warnings: Display open warnings in the header.

Pending Alarms: Display open alarms in the header.

Pending Errors: Display open errors in the header.

Unconfirmed Messages: Display unconfirmed messages in the header.

Unconfirmed Reminders: Display unconfirmed reminders in the header.

Unconfirmed Warnings: Display unconfirmed warnings in the header.

Unconfirmed Alarms: Display unconfirmed alarms in the header.

Unconfirmed Errors: Display unconfirmed errors in the header.

Step 4

Click on "Save" to save the settings.