Calibrate

<< Click to Display Table of Contents >>

Navigation:  Help > Troubleshooting > Previous Manuals > E-OM-RMS-WEB > Data Views >

Calibrate

All measuring points in RMS can be calibrated. The calibration data are stored in the database. If supported by the measuring point, the calibration data can also be written in the device. E-OM-RMS-WEB-V1.3.1_calibrate

Figure 1: Calibration function in RMS

 

Information

Description

Parameter

oTolerance: Permissible deviation of the measured value can be added in either absolute or percent values.

oReference info: User information on the reference

oEnvironment: User information on the environmental conditions

Measurement

oCurrent measured value

oReference: Reference value (manually or from another measuring point in the system)

oTemperature1: Reference value of the temperature measuring point

oDifference: shows the difference between the current value and the reference.

oResult:

E-OM-RMS-WEB-V1.3.1_adjust 2
E-OM-RMS-WEB-V1.3.1_adjust 3

Calibrations

Date and reference value(s) of the last calibrations.

Next calibration

Here it is possible to enter a reminder for the next calibration. The reminder will appear with the yellow information symbol at the due date.

1 Is only shown for humidity measuring points because the humidity measurement is also dependent on the temperature.

 

The following functions are available for acquiring the calibration values of the measuring point2:

Function

Description

Calibrate

Execution of the calibration. In the pop-up window you can enter a comment on the calibration and select between input and output calibration.

E-OM-RMS-WEB-V1.3.1_calibrate 2

Generate report

Generate a PDF report with all or the selected calibration values

Options

oAcquire in sensor

Writes the calibration values in the measuring point sensor for a possible later adjustment.

oCalibration mode3

Increases the interval of the measuring point in order to obtain faster refreshing of data during the calibration.

2 IMPORTANT: In the case of wireless data loggers, it is only possible to write to the device during the measurement interval, i.e. it can take up to the length of an interval before the data can be sent to the device.

3 Can only be used for measuring intervals greater than one minute.