Samples of possible operating modes

<< Click to Display Table of Contents >>

Navigation:  Humidity & Temperature Devices > Transmitter > XB32A >

Samples of possible operating modes

Minimum load requirements for the XB3 with voltage outputs

 

The following requirements apply to any external device or circuit connected to the XB3 transmitter with voltage outputs:

 

XB-operation-minimum-load-req-for-volt-output

 

 

In the situation where the external device uses an internal pull-up resistor the value of this resistor should meet the requirements shown below. It is also necessary to add a pull-down resistor RL connected to ground in order to be able to read 100% of the range of the XB3 voltage output.

 

XB-operation-minimum-load-req-for-volt-output-with-pull-up-resistor