Add device - Interface
This device supports USB (with a AC3001 accessory cable).
Note: If the HC2A-AW-USB cannot be added, please make sure that the USB driver is installed, see here: Driver Installation
Configuration
•To display all the possible settings for the HygroClip2, it has to be read out first by clicking on the button "Read".
•By clicking on the button "Write" all the changed settings will be applied to the device.
Device
•Calculation: Several calculation can be chosen that are based on humidity and temperature - e. g. dew point, frostpoint, vapor pressure etc.
•Description: A device name can be defined for the individual device by the user.
Language settings
•Metric and imperial can be switched for the temperature.
•The unit of relative humidity can be defined.
Analog output settings
•Parameter and
•Scaling
Fix values
•For simulation reason, fix values can be defined and activated.
Alarm
•Alarm conditions can be defined for humidity, temperature and the calculated parameter. Values that are below the low alarm value or above the high alarm value will trigger an alarm.
•The value specified for the alarm function hysteresis is used for both the low and the high alarm.
Special device configuration
•The device settings can be protected with a password.
•The RS485 address can be adjusted manually.
Adjust
The HygroClip2 has the possibility to acquire and then adjust multiple adjustment points for temperature and humidity.
•For the humidity it's possible to adjust up 100 measurement points.
•For the temperature it's possible to adjust up to 2 measurement points.