ID

Description

RMS-1656A

Improved process of saving data received by the RMS application.

ID

Description

RMS-1527A

PDF event report cutting off details from larger events.

RMS-1591A

When adding an RMS-ADC-L-R with 2 different parameters, the values of input 1 and input 2 only shows the value of input 1.

RMS-1801A

MPT name not shown correctly within PDF reports (°, ö, ü, ö...).

RMS-1814A

Help E-Mail support system information data not shown correctly (°, ö, ü, ö...).

RMS-1934A

Switch input counter measuring points not displayed.

RMS-1935A

E-Mail alarm notifications are sent when not selected.

RMS-1937A

End of inhibition of a timeout error not shown correctly.

RMS-1966A

Time periods visible for event reports.

RMS-2088A

Under chart, “null” is shown as a title for display category.

RMS-2097A

Under actions, when “reset on end of alarm” is selected, then the “reset after [s]” remains visible.

RMS-2136A

E-Mail Report limited to 32 MPT's, but under E-Mail report, more can be selected.

RMS-2220A

Several send E-Mail event for the same alarm.

RMS-2237A

Mixing ratio, enthalpy and vapor concentration are all linked to the pressure unit.

RMS-2241A

Help E-Mail support system information data missing.

RMS-2244A

Display category showing “Null”.

RMS-2253A

Number of measuring points required by the RMS-CONVERTER-100 not calculated correctly.

RMS-2288A

Alarm zone not being displayed.

RMS-2291A

Error when archiving a measuring point.

RMS-2382A

Spelling mistake under scripts: “Enter name for new measureing point”.

RMS-2424A

Alarm not closing or closes with delay when switching from a high alarm to a low alarm.

RMS-2428A

Duplicate wireless address can occur when switching a logger to a new gateway.

RMS-2496A

Phone call issue (first user is called twice).

RMS-2531A

When going from high alarm to low alarm, the alarm delay is not taken into account.

RMS-2553A

Device replace error: device already exists.

RMS-2787A

Under add a measuring point, the pressure of a calculation cannot be selected.

RMS-2788A

Under the audit trail, the unit “Pa” shows up as "Undefined".

RMS-2792A

No reminder and error notifications after the upgrade to V2.5.0.

RMS-2861A

Missing “Failed” in the event details for failed notifications.

RMS-2942A

The data reports with multiple pages always repeat the first three measurement records.

RMS-2983A

Device validation: the timeout event from the validation script remains open.

ID

Description

RMS-3120A

When setting the alarm limits to off under the measuring point, the visual of the historical limits disappear from the chart/report. This is only a visual error and does not effect the data integrity of the historical alarm settings.

RMS-3438A

A validation error will occur when data is read out from the logger once the data is already validated by the system.