RMS Report showing wrong Min/Max times, amount of warnings/alarms and incorrect measurement times

<< Click to Display Table of Contents >>

Navigation:  Help > Troubleshooting > Using RMS >

RMS Report showing wrong Min/Max times, amount of warnings/alarms and incorrect measurement times

Step 1

If in a report, the minimum and maximum times do not correspond to the those of the data analysis .csv:

 

rms report error 0

Step 2

And the amount of warnings and alarms in the report do not correspond to the amount of warning and alarms within the data analysis .csv:

rms report error 2

The .csv shows:

Total alarms: 2.

Total warnings: 6 (with multiple measurements).

 

The report shows:

rms report error 3
rms report error 4

Step 3

And the amount of measurement values do not correspond to the measurement interval:

rms report error 6
rms report error 5

Step 4

Rotronic recommend checking to see if the log interval of the devices was updated within the audit trail or if the calibration mode (log interval of 60s) was used during the time frame that the report was created for.