Info

ID

Unique ID for the measuring point (MPT-xx)

Type

Measuring point type or parameter

oMeasuring element

Measuring element (e.g. HygroClipD) that is connected directly to the device.

oPsychrometric Calculation

Psychrometric calculation from humidity and temperature.

oArithmetic Calculation

Arithmetic calculation (e.g. difference, sum, average, PT1 filter, etc.)

oVirtual button

Logical switch that can be operated by the user directly.

oSystem measuring point

A system measuring point counts events and can be monitored with an alarm threshold like a normal measuring point. It can also be used to measure the signal strength.

Types of system measuring points:

▪Switch input counter

Number of state changes of a logical input1

▪Alarm time counter

Duration of the alarm state2 of a measuring point.

▪Measuring point alarm counter

Number of measured values of a measuring point in alarm state3

▪Device refresh counter

Counts when a device sends new measured values

▪Signal strength

Measures the signal strength and writes it in the database like a measured value

▪Pending reminders

▪Pending warnings

▪Pending alarms

▪Pending errors

▪CPU load

CPU load in %

▪Memory load

Memory load in %

▪Measuring point updates

Number of updated measuring points (valid for all measuring points, also calculations and counters)

▪Pending commands

Number of Pending commands

▪Software exceptions

Number of software errors

▪Active users

Number of active users based on RMS pages loaded

▪Page loads

Number of loaded RMS pages

Status

oEnabled

Measuring point is enabled in the system.

oDisabled

The system does not receive any data from the measuring point and alarms are also not triggered.

Serial number

Serial number of the probe (only in the case of interchangeable RMS probes)

Device

Name and ID of the device, including direct link to device settings

Last refresh

Time that has passed since the system last received data from the measuring point

Settings

Name

Freely selectable measuring point name

Regulation status

Freely selectable regulation status (GMP / GLP / etc.)

Comment

Freely selectable comment

Details

Settings for a calculated measuring point or system counter

Group(s)

Group allocation (more than one group can be specified)

Alarm

Mode

oOff

No alarm evaluation.

oMeasuring point

The alarm limits are defined directly for the measuring point.

oAlarm triggers

The alarm limits are defined as alarm scheme (alarm triggers).

Warning

Enabled / Disabled

Only enabled alarms are processed in the system

Lower limit

Lower limit value

Upper limit

Upper limit value

Hysteresis

Hysteresis

Delay

Delay in alarm notification

Alarm

Enabled / Disabled

Only enabled alarms are processed in the system

Lower limit

Lower limit value

Upper limit

Upper limit value

Hysteresis

Hysteresis

Delay

Delay in alarm notification

New

Add new measuring point

Archive

All information of the measuring point data set is archived and can be viewed in the archive. The data archive is described in the E-OM-RMS-WEB document.

oGeneral measuring point information

oMeasured values

oEvents

oCalibration data

oDocuments

Delete

Delete measuring point irretrievably.4 5

To delete a device, it is also necessary to enter a text in order to prevent accidental deletion of a device.

Save        

Save measuring point settings