Installation

<< Click to Display Table of Contents >>

Navigation:  Hardware Overview > Input and Output Devices > RMS-DO-L-R >

Installation

The wall mounting is carried out using a standard DIN rail (EN 50022 / 35 mm x 7.5 mm). The rail is attached to the wall or in the control cabinet. Then just plug in the device on the DIN rail.

 

RMS-Do-L-R_wall mounting

Figure 1: Wall mounting

RMS-Do-L-R_network cable connection

Figure 2: Network cable connection

 

When plugging the network cable into the device, make sure it clicks in audibly.