Functions |
Description |
Diameter |
32 mm (1.26") |
Length |
76 mm (3") |
Housing material |
Polycarbonate, black |
Connector
All CCA probes use the same connector (male).
Connection diagram (7-pin connector, male – view: probe side)
 |
1) V+ 2) - 3) RxD 4) TxD 5) SIG 6) Not used 7) Not used |
Sensor protection (filters)
The CCA is supplied with a standard filter.
Mechanical installation
For best measurement results, observe the following points:
oFor incubator measurements, the CCA should be installed, with the sensor facing down, within the incubator. It is not recommended to add the converter box into the incubator.
oFor life safety measurements, the CCA should be installed at socket level (roughly 450 mm from the floor)
Electrical installation
Use Rotronic extension cables.