Help > Wireless Topics > Wireless Installations in RMS > Wireless Installation

Address: the time (second) when communication takes place. Address 1 corresponds to the 1st second of the minute.

The address is configured on the RMS wireless loggers. The address of RMS gateway is automatically configured as 254 and has no physical meaning.

For 868 / 915 MHz to addresses go from 1 to 60.

Selecting the address is crucial to have a running system.

Note:

If two devices have the same address then data gaps will occur!

Normally, the system will automatically select the address when integrating the data logger into the system. However, after the initial installation and with the addition of further data loggers, an address conflict may occur. Via the device overview table, an overview of the devices with the network ID, address and channel is visible.