Help > Wireless Topics > Wireless Installations in RMS > Wireless Installation - Hardware > Network Planning > Installation Recommendation

oAlways make sure that the latest firmware is installed on the devices.

oThe wireless networks can get overloaded (limited to 60 devices, with a measurement interval of 60 seconds). It is crucial to make sure that no more than 60 loggers are setup with each gateway.

oSeparation of the different radio frequency nets in the following order:

▪Channels.

▪Address.

▪Network ID (and only if it is certain that there are no overlaps to other nets).

oCheck if only one device is added per address per channel. The Net ID does not help to separate them on a physical level.

oUse channel numbers with the largest difference possible if the floors, buildings are close to one another.

oOnce a device is deactivated/deleted from RMS, make sure that it is unpaired properly (pushing on the button for a minimum of 10 s).

Please see here for more details: Wireless Installation - Software Settings