Initial Operation

<< Click to Display Table of Contents >>

Navigation:  Software Overview > RMS Monitoring Software > Working with the RMS Software > Configure RMS > Add Specific Devices to your RMS Account > RMS-ADC-L-R >

Initial Operation

Device configuration

oConnect the device to the network

oConfigure the network settings using the RMS-Config SW (Download)

Step 1

Open the RMS-Config SW

Step 2

Click on "Device" > "Search" > "Network devices"

RMS-LOG-T30-L_RMS_Config$

Note:

Please be sure that you always use the newest RMS-Config version. The newest devices do not work with the old RMS-Config version.

 

Step 3

Choose the device

RMS-ADC-L-R_rms_config_device_search

Step 4

Click "Add" > "Settings" and configure the network settings. Also the analog inputs can be configured here, but it can be done also within RMS.

 
At the end, click "Write" to save the settings.

RMS-ADC-L-R_rms_config_settings

 

 

Pairing / Integration into RMS

Step 1

Open a web browser on your computer, log in to the RMS software and select "Tools" > "Setup" > "Device" > "New" > "LAN device"

 

LAN_add_new_device

 

Step 2

Enter the serial number and click "OK"

 

LAN_add_new_device_enterSN

 

Step 3

Press the device's button

 

IMPORTANT:

Press the button after the LED starts flashing orange.

 

LAN_add_new_device_press_button

 

Step 4

The LED flashes green when connection is successful.

 

 

oConfigure the device and measurement point

RMS-ADC-L-R_integration

 

oConfigure the analog inputs (if not done with the RMS-Config)

▪Click on "Tools" > "Setup" > "Devices"

▪Choose the RMS-ADC-L-R

▪Click on "Properties Show"

RMS-ADC-L-R-configure_analog_inputs
 

oConfigure the properties of the analog inputs as needed and finish with a click on "Apply"