<< Click to Display Table of Contents >> Navigation: Hardware Overview > LOG Dataloggers > RMS-LOG-868/915 > Customer adjustment > Integration in the RMS-WEB Software |
To integrate the device, port 80 must be enabled in your network and a DHCP server must assign the IP address to the device. The device must be able to reach the server with the RMS server software or the Cloud.
The devices can also be given a static IP address if there is no DHCP server available in the network.
Integration of the Data Logger (Pairing) in 6 Steps
Step 1 |
If you do not want to connect the device to the Rotronic Cloud, the server must be configured in the device. oConnect the device to the local network and start the RMS-Configuration software. oSearch for the device under "Device" > "Search" > "Network Device". The software finds all RMS devices in the local network. oEnter the host (server address) and the URL of the software services under "Settings". oFinish configuration with "Write". |
Step 2 |
Log in to the RMS software / Cloud. Select "Extras" > "Setup" > "Devices" > "New LAN Device"
|
Step 3 |
Enter the serial number of the device. The device flashes orange.
|
Step 4 |
Press the button on the device briefly. The device stops flashing.
|
Step 5 |
Configure the device.
The RMS-D-L:
|
Step 6 |
Finish configuration.
|
You can find details in the instruction manual for the RMS server software: E-SM-RMS-WEB
To integrate the device in a RMS-WEB system, pairing mode must be enabled via the software on a gateway within wireless range. The search for the device is started by pressing a button. If it is possible for the device to connect with the gateway, this is shown by orange flashing. Pairing is then completed as described in the RMS-WEB software.
Integration of the Wireless Data Logger (Pairing) in 5 Steps
Step 1 |
Log in to the RMS software / Cloud. Select "Extras" > "Setup" > "Devices" > "New Wireless Device".
|
Step 2 |
Select the gateway you want your wireless data logger to be connected to. The selected gateway then changes to pairing mode and flashes orange.
|
Step 3 |
Press the button on the device to confirm. The wireless data logger stops flashing.
|
Step 4 |
Configure the device.
|
Step 5 |
Finish configuration.
|
You can find details in the instruction manual for the RMS server software: E-SM-RMS-WEB