Installation

<< Click to Display Table of Contents >>

Navigation:  Hardware Overview > Gateway and Converters > RMS-GW-868/915 >

Installation

The following instructions describe installation step by step.

 

Step 1

Press a blunt object (e.g. screwdriver in the AC1321 mounting kit) lightly into the hole opening on the top side of the housing. The flap springs open.
RMS-Log_Installation 1

Step 2

Press the cover to the back and take off from the basic unit.
RMS-Log_Installation 2

Step 3

The cover has two suspension openings and two additional prepared fastening possibilities.

 

Note:

Only the mounting points provided should be used for mounting.

 

 
RMS-Log_Installation 3

Step 4

Make a round opening in the large rubber seal (use the mounting cone in AC1321), pass the cable through it and fit the rubber plug in the cover.
RMS-Log_Installation 5

Step 5

Plug the cable into the device. For secure fastening and to ensure a reliable data link, make sure it clicks in audibly.

 

Note:

oThe connected cable may not exceed a length of 30 m at most. Disruptions can occur in operation if a longer cable is used!

oFor T30-868/915 no Ethernet cable.

 
RMS-Log_Installation 6

Step 6

If necessary, connect the device to a power supply.
RMS-Log_Installation 7

Step 7

The wall bracket is fastened to the wall with screws according to the drilling template. The screws may only protrude so far that the device can click into place properly when put on to the fastened cover.

 

Note:

oThe screws must not be tightened.

oOnly use the screws provided in the package. Screw specifications: M3.5. head strength 2.5 mm, head diameter 7 mm

 
RMS-Log_Installation 8

Step 8

The housing is put in the wall bracket and clicked into place.

RMS-Log_Installation 9