|
<< Click to Display Table of Contents >> Navigation: Hardware Overview > Display Devices > RMS-D-L > Device description |
The ROTRONIC RMS LAN display is a freely configurable display. As a remote display, it can be optimally placed where it best suits the viewer. The display is able to show measured values, states and alarms of RMS.
Power Supply: 24 VDC ± 10 % / 100 mA
PoE: 802.3af-2003, Class 1
The device has a button and a multicolored LED for operation and display of the operating status.
The button is used when the device is put into operation or for unpairing.
The LED indicates the device status.
Blinking |
Details |
|---|---|
1 x green / 5 s |
Normal operation. The display alternates between measurement point 1/2 and 3/4 every 5 seconds. |
Orange flashing |
Pairing process |
3 x red flashing |
Unpairing process |
Important:
If the RMS wireless device is offline for a longer period of time, then this may cause for the wireless module to be sent into failure mode. This happens when a very low power supply is supplied to the device. Once the wireless module is in failure mode, it cannot be resuscitated. Once the wireless module has failed, the device's LED will blink differently to any way that is described in the manual.
Recommendation: Please remove the batteries if the user anticipates keeping a wireless device disconnected for a longer period of time. |
The device is controlled and configured via a server application. When a device is integrated into a system, the user must confirm he is the owner of the respective device by pressing on a key.
Whether a device is integrated in the system is primarily stored on the server. However, the device retains this information each time it communicates with the server and maintains the state in the event of a reboot or loss of connection. To remove the device from the system, it must be deleted from the server.
Operation status |
Push-button pressed |
|
Pairing |
Short time |
Confirm pairing when connecting the device to the Rotronic Monitoring System. The LED flashes orange before the pairing can be confirmed. If the pairing is not confirmed, the device returns to offline mode after a certain time (determined by the RMS-WEB software). |
Online |
Long time (app. 4 to 5 sec.) |
Discard the local pairing information. Note that pairing is always set by the server. If there is a connection to the server, the pairing is immediately taken over again. |
In all operation status not listed (in the table above), the push-button has no function.
The device is equipped with a real time clock. The time is continuously synchronized if there is a connection to the server.