<< Click to Display Table of Contents >> Navigation: Hardware Overview > Input and Output Devices > RMS-DO-L-R > Step-by-Step > Add an RMS-DO-L-R to RMS |
oConnect the device to the network
oConfigure the network settings using the RMS-Config software: https://www.rotronic.com/en-ch/rms/downloads-rms
Step 1 |
Open the RMS-Config software |
|
Step 2 |
Click on "Device" > "Search" > "Network devices"
|
|
Step 3 |
Choose the device
|
|
Step 4 |
Click "Add" > "Settings" and configure the network settings. At the end, click "Write" to save the settings.
|
Step 1 |
Open a web browser on your computer, log in to the RMS software and select "Tools" > "Setup" > "Device" > "New" > "LAN device"
|
Step 2 |
Enter the serial number and click "OK"
|
Step 3 |
Press the device's button
IMPORTANT: Press the button after the LED starts flashing orange.
|
Step 4 |
The LED flashes green when connection is successful. |
oConfigure the device and measurement point.
oFinish the configuration.