Case 265
Question:
When replacing the batteries on the MLOG's the low battery reminder appears.
Possible Root Cause:
The logger is being used at temperatures lower than 10°C. In which case the battery capacity will be lower and the alarm triggered.
The RMS-BAT capacity repartition is very different and leads to battery level reminders.
Wrong battery type.
Solution:
Only use the RMS-BAT
Link:
https://www.rotronic.com/en-ch/rms-b...a-loggers.html
Additional Information:
The RMS-MLOG firmware has been updated to also measure the battery capacity.
The following firmwares and below do not measure the battery capacity: RMS-MADC-868-A (V1.2), RMS-MADC-868-V (V1.2), RMS-MDI-868 (FV1.2), RMS-MLOG-LGT-868 (V1.2), RMS-MLOG-T-868 (V1.3), RMS-MLOG-T10-868 (V1.3), RMS-MLOG-B-868 (V1.2).
When replacing the batteries on the MLOG's the low battery reminder appears.
Possible Root Cause:
The logger is being used at temperatures lower than 10°C. In which case the battery capacity will be lower and the alarm triggered.
The RMS-BAT capacity repartition is very different and leads to battery level reminders.
Wrong battery type.
Solution:
Only use the RMS-BAT
Link:
https://www.rotronic.com/en-ch/rms-b...a-loggers.html
Additional Information:
The RMS-MLOG firmware has been updated to also measure the battery capacity.
The following firmwares and below do not measure the battery capacity: RMS-MADC-868-A (V1.2), RMS-MADC-868-V (V1.2), RMS-MDI-868 (FV1.2), RMS-MLOG-LGT-868 (V1.2), RMS-MLOG-T-868 (V1.3), RMS-MLOG-T10-868 (V1.3), RMS-MLOG-B-868 (V1.2).
No matching posts in this thread.