Tweet
This is something that was not possible with previous generation Rotronic hardware.
How now if you perform a calibration within RMS on an RMS device you can subsequently acquire these calibration points in the device and adjust ... retrospectively.
This means as you calibrate a device you need only save the calibration points within RMS. If you decide once the calibration is complete that the device requires adjustment you can select teh desired cal point, 'Acquire in Sensor' and then adjust. You would then of course re-calibrate to confirm 'As Left' or 'Post Adjustment' performance.
The below screenshots give an overview. This not a new feature in RMS just one that I didn't fully appreciate and I wanted to share!
How now if you perform a calibration within RMS on an RMS device you can subsequently acquire these calibration points in the device and adjust ... retrospectively.
This means as you calibrate a device you need only save the calibration points within RMS. If you decide once the calibration is complete that the device requires adjustment you can select teh desired cal point, 'Acquire in Sensor' and then adjust. You would then of course re-calibrate to confirm 'As Left' or 'Post Adjustment' performance.
The below screenshots give an overview. This not a new feature in RMS just one that I didn't fully appreciate and I wanted to share!